Results 1 to 8 of 8

Thread: New RSV Owner. Bike is in Dealer Mode

  1. #1
    Baby Twin
    Join Date
    Aug 2011
    Location
    Altadena, CA
    Posts
    4

    New RSV Owner. Bike is in Dealer Mode

    I bought this from a friend who hasn't ridden it in many years.

    I have a 2000.5 Mille RSV R, and it seems to be in dealer mode. I start the bike, EFI comes on for a few seconds, disappears then comes up with DIAG 0. and stays there.

    I know it's not throwing any faults cause it's showing zero. But for the life of me I can't find/figure out where connector 68 is so that I can disconnect it and make everything all better.

    Can anyone show me a picture? I can't find crap on the interwebs, and the technical training course manual has a crappy pixelated picture that I can discern anything from.

    Other than that, the bike runs great! Thanks!

  2. #2
    Superbike Twin Sensei's Avatar
    Join Date
    Oct 2010
    Location
    Taranaki NZ
    Posts
    193
    Take the right hand side pannel off under the seat & there should be a single wire barrel connector amoungst the frame wire loom take these apart Job done ! Then try again should be all good to go ....

    Check pic in this post of what you atre looking for ..

    http://www.apriliaforum.com/forums/s...ault+connector
    Last edited by Sensei; August 25th, 2011 at 10:28 PM.

  3. #3
    Baby Twin
    Join Date
    Aug 2011
    Location
    Altadena, CA
    Posts
    4

    Thanks!

    I don't remember seeing anything like that down there. I'll check again. After some inspection it appears that maybe this has some aftermarket turn signal thing added? Ever heard of that maybe screwing up things?

  4. #4
    Superbike Twin Sensei's Avatar
    Join Date
    Oct 2010
    Location
    Taranaki NZ
    Posts
    193
    If the dash is showing Diag -0 then the connector is still joined ...

  5. #5
    Baby Twin
    Join Date
    Aug 2011
    Location
    Altadena, CA
    Posts
    4

    Awesome!

    Thanks guys. That picture did the trick. Seriously, I can't believe that there aren't more good photos like that running around.

    So one more question:

    Since my bike was throwing a DIAG 0 code (which is good) and I took the bike out of Dealer Mode, it is showing "service". I'm guessing that this is just the regular XXXX miles on the bike when it says "Service" for like fluid changes and stuff right?

  6. #6
    Baby Twin Frank O's Avatar
    Join Date
    Aug 2011
    Location
    Suffolk, U.K.
    Posts
    10
    http://rsvzone.com/forums/showthread...=service+reset

    See above for reset if it's a newer model :-)

  7. #7
    Baby Twin
    Join Date
    Aug 2011
    Location
    Altadena, CA
    Posts
    4
    Much to my dismay, it's not. It's a 2000.5. Any direction on how to reset it on those models?

  8. #8
    pat
    pat is offline
    Evil Twin pat's Avatar
    Join Date
    Oct 2010
    Location
    Inveraray,Argyll
    Posts
    474

Similar Discussions

  1. New owner with lots of problems on the bike
    By PedroMoreira in forum Aprilia RSV4
    Replies: 8
    Last Post: January 18th, 2013, 02:38 AM
  2. This Bike has a new owner
    By V_senna in forum Aprilia RSVR
    Replies: 8
    Last Post: January 29th, 2010, 05:05 PM
  3. Bike has a new owner
    By Smiffy in forum Aprilia RSVR
    Replies: 41
    Last Post: January 16th, 2010, 02:56 PM
  4. Cheap enough bike from dealer?
    By twintorque in forum Classifieds
    Replies: 2
    Last Post: December 31st, 2009, 10:18 AM
  5. How do you get the bike out of diagnostics mode?
    By V_senna in forum Aprilia RSVR
    Replies: 2
    Last Post: August 29th, 2009, 03:01 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •