Results 1 to 8 of 8

Thread: Diagnostic codes starting with P

  1. #1
    Superbike Twin pjefferi's Avatar
    Join Date
    Jan 2009
    Location
    Milton Keynes, England
    Posts
    105

    Diagnostic codes starting with P

    I'm getting to the end of my tether trying to find a fault. I have fault code P14 showing up on my 2004 RSV1000R. The manual states that faults begining with P aren't listed.

    Does anybody know what the P codes are?

    All elese failed I'm going to have to put her in the Aprilia dealer for a number of days until they can trace the fault....

  2. #2
    Gasboy
    Guest
    Chill !! Someone on here will know !!

  3. #3
    AMA Pit Boss Sprocker's Avatar
    Join Date
    Oct 2010
    Location
    Pontefract, W.Yorks
    Posts
    4,335

  4. #4
    spoonz
    Guest
    P codes are ghost codes generated by a poor connection usually on a sensor or module on the can bus.

    The P means it not recognised by the ecu fault list.

  5. #5
    Superbike Twin pjefferi's Avatar
    Join Date
    Jan 2009
    Location
    Milton Keynes, England
    Posts
    105
    Quote Originally Posted by spoonz View Post
    P codes are ghost codes generated by a poor connection usually on a sensor or module on the can bus.

    The P means it not recognised by the ecu fault list.
    Thanks Spoonz - I'll check all the sensors. When you say module, where would I find them?

  6. #6
    spoonz
    Guest
    By module i mean dash. immobilisor etc.

    The ecu will check for missing or incorrect voltage readings from most things on the can but a dodgy connection etc can throw up spurious codes it doesn't recognise.

    Around the left inner fairing can be a good place to start as the connectors tend to get wet and corrode there. Especially the white one above the immobilisor ecu.

    check the connectors in the tail unit and 30 amp fuses near batt for decent connection too.

  7. #7
    Superbike Twin pjefferi's Avatar
    Join Date
    Jan 2009
    Location
    Milton Keynes, England
    Posts
    105
    You are a good man Spoonz thanks for the advice. I'll start checking that area.


  8. #8
    Baby Twin
    Join Date
    Dec 2011
    Posts
    4

    I have a problem with my dashboard.

    Guys,

    my error light is blinking and I cannot start my bike.

    is it my dash board that is the problem? can I swap to the translogic microdash 2?

Similar Discussions

  1. How I fixed my TPS- DIAGnostic 1
    By superyellow in forum Aprilia RSVR
    Replies: 13
    Last Post: May 13th, 2012, 12:54 AM
  2. How do you put a 06 rsv in Diagnostic mode?
    By hstephen5 in forum Aprilia RSVR
    Replies: 0
    Last Post: September 21st, 2009, 01:50 AM
  3. EFI warning Diagnostic/Fault codes 11 and 12
    By superyellow in forum Aprilia RSVR
    Replies: 2
    Last Post: January 16th, 2009, 12:09 AM
  4. Need help with engine diagnostic codes (EFI)
    By Wolf in forum Aprilia RSVR
    Replies: 16
    Last Post: May 26th, 2008, 07:42 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •