Results 1 to 10 of 10

Thread: LED settings and buttun designations?

  1. #1
    Retired daveC's Avatar
    Join Date
    Jun 2007
    Location
    Carlisle UK
    Posts
    62

    RSV1000 Mille/ SL1000 Falco LCD Dash Functions

    Resetting the service light
    • Key on
    • Press Lap and R for 5 seconds


    Switching KM/H to MPH
    • Key on
    • Press A about 5 seconds until blinking
    • Press B to change unit of measurement
    • Press A for 5 seconds to confirm choice

    V max
    Uses trip odometer #1 (the odometer displayed during instantaneous speed)
    • To reset trip odometer #1 press R for 2 seconds
    • To display V max and distance of trip odometer 1 press B for 2 seconds
    • To reset V max press R for 2 seconds


    AVS (Average Speed)
    • Uses trip odometer #2
    • Hold down B for 2 seconds and then press again
    • AVS is displayed along with distance of trip odometer #2
    • To reset both AVS and trip odometer #2 press R for 2 seconds

    Redline threshold (engine off only)
    • Press C, release, and press again
    • Release C when desired RPM is reached

    Battery voltage
    • Press D once

    Setting hour
    • Press D twice
    • Press LAP until desired hour is reached
    • Press D to confirm

    Setting minutes
    • Press D three times
    • Press LAP until desired minutes is reached
    • Press D to confirm

    Setting C or F
    • Press D a fourth time
    • Press LAP to alternate units


    Chronometer (Lap Timer)
    • V max, AVS, and trip odometer #2 no longer function in this mode
    • Press LAP and within 0.7 seconds press D to enter chronometer mode
    • To start timing press LAP and release immediately
    • To store a lap time press LAP
    • To display lap times press B
    • To cycle through the stored laps, press LAP
    • To reset memory press A and LAP for 2 seconds
    • To leave chronometer function press LAP and D

  2. #2
    Baby Twin wrex's Avatar
    Join Date
    May 2008
    Location
    Kansas City, Mo
    Posts
    1

    LED settings and buttun designations?

    Referring to post: http://www.rsvzone.com/forums/showthread.php?t=43

    Great write up. My 04 didn't come with a manual, so forgive the n00b question, but what buttons that you refer to are A, B, C and D? Trying to reset my Temp gauge to F.

    Thanks!

  3. #3
    Baby Twin stinky's Avatar
    Join Date
    Jun 2008
    Location
    courchevel, france
    Posts
    25
    @ DAVE C
    You are a star!!!!!!!!!! The service light has been doing my head in all summer - took a good 10 seconds on the buttons though, but I'd have kept them pressed down for 10 hours just to clear the blasted thing of the screen - THANKS

    @ Wrex - I assume as you posted in May that you have found the buttons by now.......if not, they're the rubber covered buttons on the instrument panel, under the speedo/tacho

  4. #4
    Baby Twin
    Join Date
    Nov 2008
    Posts
    3
    cheers, brilliant thanks

  5. #5
    littlescrote
    Guest
    do you know if there's any way to make the display show the air temperature using the sensor connected to the ECU?

    there is nothing about it in the workshop manual, but perhaps some combination with the test point connected?

  6. #6
    Baby Twin piersvr's Avatar
    Join Date
    Jul 2009
    Location
    Nottingham
    Posts
    14
    Ah ha your a star my times out n been bugging the S*** outta me i dont know if that OCD but its sure annoying thanks

  7. #7
    Baby Twin chris13's Avatar
    Join Date
    Jun 2009
    Posts
    99
    What a useful bit of info. Battery dropped a bit earlier and everything reset to default. Did rev limit, MPH, clock and service interval. These guides are ace

    Cheers

  8. #8
    Baby Twin robsrsv's Avatar
    Join Date
    Aug 2009
    Location
    Indpls,IN
    Posts
    31
    Thanks great info

  9. #9
    One Liter Duc Eater w00dzy's Avatar
    Join Date
    Dec 2012
    Location
    Near Portsmouth
    Posts
    855
    Bookmarked thanks very much

  10. #10
    Baby Twin
    Join Date
    Nov 2010
    Location
    N.Ireland
    Posts
    10
    Cheers Great Info

Similar Discussions

  1. O2 settings???
    By andirsv in forum Aprilia RSVR
    Replies: 7
    Last Post: January 21st, 2012, 03:26 AM
  2. Can I change map settings myself?????
    By DeanRSV in forum Aprilia RSVR
    Replies: 3
    Last Post: December 5th, 2009, 03:35 AM
  3. Sag settings
    By caveman47 in forum Aprilia RSVR
    Replies: 5
    Last Post: November 14th, 2009, 05:50 AM
  4. sag settings
    By kevcole in forum Aprilia RSVR
    Replies: 3
    Last Post: July 27th, 2009, 01:19 PM
  5. Co2 settings
    By Sabre in forum Aprilia RSVR
    Replies: 10
    Last Post: September 3rd, 2008, 03:15 AM

Search tags for this page

Click on a term to search for related topics.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •